Western Blot analysis for the detection of viral proteins

Procedure

Sample Preparation

  • Collect virus-infected cells lysate and add appropriate volume of protein lysis buffer containing SDS and reducing agent.
  • Mix gently and heat the samples at 95 °C for 10 minutes to denature proteins.
  • Briefly centrifuge at 12000g for 5 minutes and keep samples on ice until loading.

SDS-PAGE (Protein Separation) and Transfer of Proteins to Membrane

  • Assemble the SDS-PAGE gel apparatus and load protein samples and a pre-stained protein molecular weight marker into separate wells.
  • Run the gel at appropriate voltage until the dye front reaches the bottom.
  • Carefully remove the gel, activate the PVDF membrane by soaking it in methanol, and then equilibrate it in the transfer buffer.
  • Transfer proteins from the gel to the membrane using a wet or semi-dry transfer system at recommended conditions.
  • Incubate the membrane in blocking buffer (5% skimmed milk or BSA in TBST) for 1 hour at room temperature to prevent non-specific binding.

Antibody Incubation and Detection

  • Incubate the membrane with primary antibody specific to the viral protein for 1-2 hours at room temperature or overnight at 4 °C.
  • Wash the membrane 3 times with TBST to remove unbound primary antibody.
  • Incubate the membrane with enzyme-conjugated secondary antibody for 1 hour at room temperature.
  • Wash the membrane again 3-4 times with TBST.
  • Add appropriate substrate solution (e.g., chemiluminescent substrate).
  • Observe the signal using a gel documentation system.
  • Record the appearance of protein bands at the expected molecular weight [2].